Adaptador de banco CTS para ECM Detroit DDEC III y DDEC IV con sus conectores de ECM y el conector gris hacia el cable base

Detroit DDEC III / DDEC IV Bench Adapter for ECM Programming

$129.00
$129.00
Skip to product information
Adaptador de banco CTS para ECM Detroit DDEC III y DDEC IV con sus conectores de ECM y el conector gris hacia el cable base
  • Adaptador de banco CTS para ECM Detroit DDEC III y DDEC IV con sus conectores de ECM y el conector gris hacia el cable base
  • Adaptador de banco CTS conectado a un ECM DDEC en el banco
  • Adaptador de banco CTS para ECM Detroit DDEC III y DDEC IV con sus conectores de ECM y el conector gris hacia el cable base
  • Adaptador de banco CTS conectado a un ECM DDEC en el banco
Detroit DDEC III / DDEC IV Bench Adapter for ECM Programming

DETROIT SERIES 60 · DDEC III · DDEC IV

Detroit DDEC III / DDEC IV Bench Adapter for ECM Programming

$129.00
$129.00
  • Works or we
    swap it: 30 days
  • Ships next
    business day
  • Free shipping
    over $250Otherwise $12.95
Cable base de banco CTS con pinzas de batería, conector redondo de diagnóstico de 9 pines y salida gris para el adaptador

You need the base cable

You buy it once and it works with every adapter.

Base cable
$169
This adapter
$129
Together
$298

✓ Together they ship free in the U.S.

Already have the base? Use the add to cart button above.

Sure it's your ECM? Check the adapter guide

Connects a Detroit DDEC III or DDEC IV ECM (Series 60) to the CTS bench base cable so you can read and program it on the bench, no truck needed.

  • ECM side: the DDEC III/IV ECM connectors
  • Base side: gray connector that plugs into the CTS base cable
  • Communication: J1708/J1587, used by DDEC III and DDEC IV, and J1939 on DDEC IV units that have it
  • Protection: braided sleeve and heat shrink

Requires the CTS base cable ($169), which you buy once.

Everything about this cable

How it works
  1. Plug the adapter into the ECM and into the base cable.
  2. Clip the leads to a 12 V battery or power supply and turn on the ignition switch.
  3. Connect your interface (Nexiq USB-Link, DLA+ or any RP1210 adapter) to the round 9-pin diagnostic connector.
  4. Open your programming software and work the ECM on the bench, no truck needed. When the software asks you to cycle the key, use the same switch.
What is NOT included
  • The communication interface (Nexiq, DLA+ or other)
  • Programming software or its licenses
  • The battery or power supply, or the ECM

Not sure it fits? Message us on WhatsApp with a photo of your ECM and we will confirm.

Works or we swap it: 30 days when CTS is at fault (exchange, not refund) + 12 months against manufacturing defects. CTS is an independent manufacturer; Detroit Diesel, Freightliner, Cummins and Caterpillar are mentioned only to show compatibility.

Complete it with