PACCAR · MX-11 · MX-13 · EPA17 · ACM · J1939
NEW
PACCAR EPA17 ACM Bench Adapter for Bench Programming
- Works or we
swap it: 30 days - Ships next
business day - Free shipping
over $250Otherwise $12.95

You need the base cable
You buy it once and it works with every adapter.
- Base cable
- $169
- This adapter
- $129
- Together
- $298
✓ Together they ship free in the U.S.
Already have the base? Use the add to cart button above.
Sure it's your ECM? Check the adapter guide
Connects the ACM (aftertreatment control module) of a PACCAR EPA17 engine to the CTS bench base cable so you can read and program it on the bench, no truck needed.
🇺🇸 Made in USA, in Houston, Texas, from domestic and imported components.
- Fits: ACM on PACCAR MX-11 and MX-13 EPA17 engines (Kenworth and Peterbilt)
- ACM side: the ACM connector
- Base side: gray connector that plugs into the CTS base cable
- Communication: J1939
- Protection: braided sleeve and heat shrink
Requires the CTS base cable ($169), which you buy once.
Everything about this cable
How it works
- Plug the adapter into the ECM and into the base cable.
- Clip the leads to a 12 V battery or power supply and turn on the ignition switch.
- Connect your interface (Nexiq USB-Link, DLA+ or any RP1210 adapter) to the round 9-pin diagnostic connector.
- Open your programming software and work the ECM on the bench, no truck needed. When the software asks you to cycle the key, use the same switch.
What is NOT included
- The communication interface (Nexiq, DLA+ or other)
- Programming software or its licenses
- The battery or power supply, or the ECM
Not sure your ACM is a PACCAR EPA17? Message us on WhatsApp with a photo of the label and we will confirm it.
Works or we swap it: 30 days when CTS is at fault (exchange, not refund) + 12 months against manufacturing defects. CTS is an independent manufacturer; Detroit Diesel, Freightliner, Cummins, Caterpillar, PACCAR, Kenworth and Peterbilt are mentioned only to show compatibility.